Operation; Remote Control - Edenwood CURVE SYSTEM 18P Manual Del Usuario

B
Product usage
Disconnecting the speaker system from a power source
1. Slide the MAIN POWER SWITCH to the O position. The POWER LED INIDCATOR will turn off.
2. Unplug the power cable from the system's AC socket and the mains socket.
NOTE: Always unplug the speaker system from the power supply when you are
not planning to use it for a long period of time.
Replacing the fuse
Should your amplifier's output power exceed the speaker's load capacity, the fuse will blow
and need to be replaced.
Warning!
• When replacing the fuse, you must use the exact same type: a cylindrical
time-delay fuse - Ø 5 x 20 mm, type L5T, T3.15 AL/250 V AC.
1. The fuse is located beneath the subwoofer/amplifier's AC socket.
2. Unplug the power cable from the subwoofer/amplifier.
3. Insert a flathead screwdriver into the small notch and lift up the fuse cover.
4. Insert the new fuse and close the cover.

Operation

Once you have set up the speaker system, you can either use the external audio source's
controls (if available) or the MEDIA PLAYER panel and the system's sound settings on the back
of the subwoofer/amplifier to play music and achieve an optimal sound. The remote control is
a flexible way to remotely control music playback. To learn more about the various functions
and how to use these commands, please refer to the table in the Product overview – Parts
section of this manual.

Remote control

Inserting the battery
Push the release clip on the battery compartment downwards and lift to remove the
cover.
Insert 2 x 1.5 V AAA batteries (not supplied) the correct way around, by observing the
polarity (+ and -) indicated on the battery compartment.
Place the furthest end of the cover in position on top of the battery compartment.
Then press the nearest end of the cover until you hear it click firmly into place.
32 EN