SAFETY INFORMATIONS FOR BATTERY
A Lithium-ion battery pack can remain in charger without damaging the battery or the charger. The
battery will remain fully charged in the charger.
If you remove the battery pack from the battery compartment before the battery is fully charged, it will
not cause any damage to the battery. lf several charging operations are performed consecutively, the
charger can become warm. lt is normal and does not indicate any technical defect.
The efficiency of discharge of the battery will decrease in the low temperature. When the
circumstance temperature is lower than -10°C, the battery pack will shut down automatically and it is
normal that the power tool is unable to use.
The internal temperature of the battery will continuously increase in repeatedly high power operation
or overload. lf the pack is overheated, it will disconnect automatically. The power tool does not work
until the temperature goes down to the normal temperature.
Do not use the battery pack if it is damaged and liquid is leaked from the battery pack cells. lf this
leakage gets on your skin, please wash affected part immediately and observe any skin reaction. lf
necessary, please seek medical attention.
Do not allow children to play with this tool or it`s packing and explain that it is not a toy and must not
be played with.
Periodically inspect the charger for damage. If it is damaged, it may only be used after a repair.
This tool is not intended for persons (including children) with limited physical, sensory or mental
capabilities or a lack of experience and knowledge, unless they have been supervised by a person
responsible for their safety or instructed in the use of the device.
POWER TOOL USE AND CARE
Do not force power tools. Use correct power tools for your application. The correct power tools will do
the job better and safer at the rate for which it was designed.
Do not use power tools if the switch does not turn it on and off. Power tool that cannot be controlled
with the switch is dangerous and must be repaired.
Stay alert, watch what you are doing and use common sense when operating power tool.
Do not use tools while tired or under the influence of drugs, alcohol, or medications. A moment of
inattention while operating power tools may resuIt in serious personaI injury.
Always wear safety goggles or eye protection when using these tools.
Secure the material being worked on. Never hold material it in your hand or across your legs.
Unstable support can cause lass of control and injury.
Avoid accidental starting. Ensure the switch is in the Off position before using these tools.
Do not overreach. Keep proper footing and balance at all times. This enables better control of power
tools in unexpected situations.
Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving parts.
Loose clothes, jewelry or long hair can be caught in moving parts.
lf devices are provided for the connection of dust extraction and collection facilities, ensure these are
connected and properly used. Use of these devices can reduce dust related hazards.
Use auxiliary handles (incl. in set). Loss of control can cause personal injury.
This power tool must serviced by a qualified repair person. Always using only identical replacement
parts. This will ensure that the safety of the power tools' is maintained.
Wear ear protectors. Exposure to noise can cause hearing lass.
Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personaI injury.
Hold power tools by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord.
Keep hands away from all edges and moving parts.
Maintain labels and nameplates. These carry important information. If unreadable or missing, contact
a service facility for a replacement.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed