Daitsu DSF-9UIEE Manual Del Usuario página 12

Introduction for buttons on remote controller Introduction for buttons on remote controller
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is depend on indoor ambient temperature).
● Set temperature range from remote controller: 16~30ºC ; Fan speed: auto, low
speed, medium speed, high speed.
3
+/- button
● Press "+" or "-" button once increase or decrease set temperature 1ºC.
Holding "+" or "-" button, 2s later, set temperature on remote controller will
change quickly. On releasing button after setting is finished, temperature
indicator on indoor unit will change accordingly. (Temperature can't be adjusted
under auto mode).
● When setting TIMER ON, TIMER OFF or CLOCK, press "+" or "-" button to
adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons).
4
FAN button
Pressing this button can set fan speed circularly as: auto (AUTO), low ( ) ,medi-
um ( ), high (
Note:
● Under AUTO Speed, IDU fan motor will adjust the fan speed (high, medium or
low speed) according to ambient temperature.
● Fan speed under dry mode is low speed.
5
I FEEL button
Press this button to start I FEEL function and " " will be displayed on the remote
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and " " will disappear.
● Please put the remote controller near user when this function is set. Do not put
the remote controller near the object of high temperature or low temperature in
order to avoid detecting inaccurate ambient temperature.
6
button
Press this button to set HEALTH function ON or OFF. After the unit is turned on, it
defaults to HEALTH function ON.
● This function is applicable to partial of models.
).
Auto
9