Quantum 2U Guia De Inicio Rapido página 3

2U Rackmount Quick Start Guide
Installing a Tape Drive in the
2U Rackmount
Follow these instructions to install a second tape drive or to
reinstall a tape drive after it has been removed for servicing.
C : Before performing this procedure, you must
AUTION
turn off the 2U Rackmount and disconnect it from its
power source.
1 Turn off the 2U Rackmount by pressing and holding the
power button on the front panel for three seconds.
2 Disconnect the power cable from the back of the
2U Rackmount.
3 Slide the 2U Rackmount out of the equipment rack.
4 Loosen the captive thumbscrews securing the top cover.
Slide the cover forward, then lift up to remove it. See
figure 5.
Figure 5 Removing the Top Cover
5 Install two thumbscrews into the side of the tape drive
that will be located next to the outer wall of the
2U Rackmount. See figure 6
thumbscrew locations.
N : Extra thumbscrews are stored inside the
OTE
2U Rackmount (see
appropriate for your unit: SDLT 320 tape drives
use 6-32 (silver) thumbscrews; all other tape
drives use M3 (black) thumbscrews.
All manuals and user guides at all-guides.com
and figure 7 for
figure 6). Use the type
Figure 6 General Thumbscrew
locations
0
Figure 7 Specific Thumbscrew
Locations and Types
SDLT 320 (6-32)
LTO-3 (M3)
Extra
thumbscrews
SDLT 600 (M3)
DLT-S4 (M3)
3