Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY INSTALLATION
The Laser Rangefinder uses a replaceable CR2 3-volt lithium
battery. To install, remove the battery cap located on the side of the
device. Insert battery negative end first (flat end) and close battery cap.
1.
Lift hatch tab.
2.
Turn counterclockwise to open.
3.
Insert battery into chamber (negative end first).
4.
Replace battery cap and tighten by turning clockwise.
NOTE:
If the Low Battery Icon is present on LCD display, there are
approximately 200 ranges left from the time the Low Battery Icon first
appears until the battery is completely drained. The Low Battery Icon
will flash if the battery life is very low. In this case, the battery needs to
be replaced before next use.
4 BATTERY INSTALLATION
Publicidad
Tabla de contenido
