Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY INSTALLATION
The Laser Rangefinder uses a replaceable CR2 3-volt lithium battery.
To install, remove the battery cap located on the side of the device.
Insert battery negative end first (flat end) and close battery cap.
1.
Lift hatch tab.
2.
Turn counterclockwise to open.
3.
Insert battery into chamber (negative end first).
4.
Replace battery cap and tighten by turning clockwise.
NOTE:
When the Low Battery Icon first appears on LCD display, there
are approximately 200 ranges left until the battery is completely drained.
The Low Battery Icon will flash if the battery life is very low. In this case,
the battery needs to be replaced before next use.
NOTE:
The HYBRID RANGEFINDER uses two different batteries.
The Laser Rangefinder only uses the CR2 3V (replaceable) battery.
The internal GPS module uses the internal lithium ion rechargeable
(non-replaceable) battery. This GPS feature requires charging
(see Page 13 for GPS charging instructions).
ENGLISH
5
Publicidad
Tabla de contenido
