Descargar Imprimir esta página

ABB Thomas & Betts Blackburn IPC 402-8K Instrucciones De Instalación página 2

Conjunto de conectar perforador de aislamiento y conector de neutro

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING CONNECTOR COVER OVER
THE INSULATION PIERCING CONNECTOR
7) Place the Connector Cover (Sold Separately) under
the connector and lift up (see Figure 7).
Lift Cover from
under the Cables
Figure 7
8) Close Lid making sure the latches snap shut
(see Figure 8).
9) If desired, a utility lock (not supplied) may be added
to the connector cover (see Figure 8).
Close Lid
until it snaps shut
Place Utility
Lock Here
(not supplied)
Figure 8
INSTALLING NEUTRAL CONNECTOR
ON NEUTRAL CABLE
10) Place the Neutral Connector on the Neutral cable
(see Figure 9).
Neutral Cable
Figure 9
ADDITIONAL PRODUCTS SOLD SEPARATELY
Catalog Number
Description
IPC-402-8
Piercing Connector
IPC-402-8N
Neutral Connector
IPC-402-8C
IPC Cover
IPC-402-8K
IPC Single Phase Kit
© 2013 Thomas & Betts. All Rights Reserved.
Lid
Connector
Cover
Neutral
Connector
Contents
Piercing Connector
Neutral Connector
Connector Cover
Piercing & Neutral Connectors, Cover
Thomas & Betts Corporation, Memphis, Tennessee
11) Hold the Neutral Connector in place on the cable
and tighten the setscrew with an insulated wrench
until the screw head shears off (see Figure 2 and 3).
OPTIONAL Alignment Tool see step 2.
12) Continue to tighten the setscrew until the screw
head shears off (see Figure 10).
Neutral Cable
Figure 10
13) Install Neutral Service Cable into one of the cable
ports (see Figure 11).
14) Once installed, tighten setscrew on back of
connector to 60 in-lbs. (see Figure 11).
Figure 11
15) For additional Customer Service Cables, repeat
steps 13 - 14 (see Figure 12).
NOTE: Neutral Service Cables may enter from either
side of the connector (see Figure 12).
Figure 12
WARRANTY: Thomas & Betts sells this product with the understanding that the user will
perform all necessary tests to determine the suitability of this product for the user's
intended application. Thomas & Betts warrants that this product will be free from defects
in materials or workmanship for a period of two (2) years following the date of purchase.
Upon prompt noti cation of any warranted defect, Thomas & Betts will, at its option, repair
or replace the defective product. Misuse, misapplication or modi cation of Thomas & Betts
Products immediately voids all warranties.
Limitations and Exclusions:
CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER WARRANTIES
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE
SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS
LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER
NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT,
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
www.tnb.com
Screw Head
Sheared off
Neutral Service Cable
Tighten Setscrew
to 60 in-lbs.
Neutral Service
Cable
THE ABOVE WARRANTY IS THE SOLE WARRANTY
TA04672 A
Page 2 of 2

Publicidad

loading

Este manual también es adecuado para:

Thomas & betts blackburn ipc 402-8Thomas & betts blackburn ipc 402-8 n