Duronic DH20 Manual De Instrucciones página 17

Problem
Unit does not operate
Dehumidifying capacity is low
Relative Humidity
setting not reached after long
period of operation.
Water is leaking
Outlet air is warm
Water noise
Troubleshooting
Cause
Unit power cord is unplugged
Unit has not been turned on.
The water light is flashing.
Runtime is too short.
Air filter is dirty and/ or obstructed.
Ambient room temperature or
humidity is too low.
Humidity setting is higher than
the ambient humidity
Drainage water pipe is blocked
or flat.
Windows and doors are not closed
or sealed.
The unit is not placed on a flat
stable surface.
Heat exchanging process
Refrigerating fluid is flowing.
17
Solution
Disconnect the plug and connect
it again or please check if outlet is
properly functioning.
Turn on the switch.
Water tank is full, empty the tank;
make sure the tank is correctly
placed back into the compartment.
Increase the operation time
using the timer function.
Use water and a damp cloth to
clean the filter.
Dehumidifying capacity is normally
lower if the room temperature is
below 18°C. please try to increase
the room temperature.
Set the humidity down and
lower than the ambient humidity.
Check the water pipe and replace
it if necessary.
Close the door and window or
enclose the space.
Place the unit on a flat and stable
surface.
This is normal
This is normal