BALANCING ACCESSORIES
To true up or balance an accessory, slightly loosen collet nut
and give the accessory or collet a 1/4 turn. Re tighten collet
nut and run the Rotary Tool .To maintain balance on abrasive
wheel points, before each use, with the wheel point secured
in the collet, turn on the Rotary Tool and run the Dressing
Stone lightly against the revolving wheel point. This removes
high spots and trues up the wheel point for good balance.
Uses
Accessory Included with Kit
Cutting
Abrasive Cutting Discs
8 pcs 1" (24mm) cut-off wheels 0.024-inch
(0.6mm) Thickness
Sanding
4pcs 1/2"(12.5mm) sanding bands
1pc 1/2" (12.5mm) sanding drum
Sanding
3pcs ¾" (20mm) sanding papers
Polishing
2 pc 1" (25mm) polishing wool wheels
Wheels
2 pcs 1/2"(12.5mm) polishing wool wheels
Grinding
10pcs aluminum oxide grinding stones
2pcs diamond grinder bits
1pc 1" (25mm) grindstone
Drilling
2pcs HSS twist drill bits
ACCESSORIES
USING ACCESSORIES
There are a variety of attachments supplied with this tool.
Some of these come ready to use and can be fitted to the
tool without any further assembly. However, others require
fitting to a mandrel before they can be used. Here is a list of
accessories.
Accessory
Mandrel used with Accessory
NONE
NONE
15