Hama 00012362 Instrucciones De Uso página 5

Warning – Batteries
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Before you insert the batteries, clean the battery
contacts and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not being
used for an extended period (unless these are being kept
ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from
the product.
• Avoid storing, charging or using the device in extreme
temperatures and extremely low atmospheric pressure
(for example, at high altitudes).
4. Getting started – installing the Batteries
Note
• Alkaline batteries are recommended. Use
2 „AAA" (LR 03/Micro) type batteries.
• Remove the battery compartment lid on the back of
your URC (A).
• Check the required battery polarity and insert batteries
according to the "+/–" marks inside the compartment
(B).
• Close battery compartment lid (C).
Note – Code saver
Any codes you have programmed remain stored for up to
10 minutes while you replace the battery. Make sure you do
not press any buttons before you have placed new batteries
inside the remote control. All the codes will be erased if a
button is pressed while there are no batteries in the remote
control.
Note – Battery saving function
The remote control switches off automatically when a
button is pressed down for more than 15 seconds. This
conserves battery power if the remote control gets stuck in
a position where the buttons are continually pressed down,
such as between sofa cushions.
5. Setup
Note
• To obtain a proper infrared (IR) transmission, allways
point your Remote control in the approximate direction
of the device you want to control.
• Press the "MODE" key to select the secondary device
group: AUX, AMP, DVB-T, CBL.
• Press the Shift key to operate the blue function keys. The
Shift function deactivates by pressing the Shift key again,
or automatically after approx. 30 sec. without use.
• No entry for approx. 30 seconds will time out the Setup
mode. The LED indicator shows six flashes and turns off.
• Each device type can be programmed under any device
key, i.e a TV can be programmed under DVD, AUX, etc.
• If you want to control a device , it´s not possible while
the Universal Remote Control is in the Setup Mode.
Exit the Setup mode and select the device you want to
control using the device selection keys.
3