Cutting Grass; Vertical Cut / Lawn Edge Trimming; Cleaning And Maintenance; Cleaning - Grizzly Tools ART 4032 Lion Traducción Del Manual De Instrucciones Original

GB
out too quickly. Use the edge of the
protective cover to keep the appli-
ance away from such obstacles.

Cutting grass

Cut tall grass by a series of levels
from top to bottom.
Vertical cut / lawn edge
trimming
Be particularly careful and at-
tentive when holding the cutter
head vertically. To avoid injuries,
keep enough distance to the
trimming assembly.
Setup for vertical trimming:
Move the appliance to the right
and left in a slow swinging motion
to trim slopes and steep inclines.
• Handle rod: 180° (see
• Remove the spacer if not nee-
ded.
Setup for edge trimming:
To trim lawn edges, slowly move
the appliance along the lawn edg-
es.
• Handle rod: 90° (see
• Remove the spacer if not nee-
ded.
52
Cut the grass by
swaying the trim-
mer sideways to
the right and left.
Cut slowly while the
trimmer is tilted for-
wards by approx.
30°.
ƒ
)
ƒ
)

Cleaning and maintenance

Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
• After every trimming session, remove
grass and soil from the protective co-
ver and the trimming assembly.

General maintenance

• Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts.
Check that the screws in the cutting
disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.