Kohler K-2816 Guia De Instalacion página 7

Install the Lavatory (cont.)
NOTE: The lavatory is designed to be installed flush or slightly
lower than the surrounding tile.
Provide shims, or route the underlayment, as needed.
CAUTION: Risk of personal injury or product damage. Handle
with care. Product can break, chip, or cause injury if handled
carelessly. Get help lifting the lavatory.
Position the lavatory in the countertop opening. Verify the fit and
position.
Carefully remove the lavatory.
Install the drain to the lavatory according to the drain
manufacturer's instructions.
Place a 1" (2.5 cm) spot of sealant at each corner of the frame
where it will contact the lavatory.
NOTE: Apply additional sealant if using shims.
Carefully re-position the lavatory.
Press down firmly.
Tile and grout to allow an acceptable space between the tile and
lavatory.
Use sealant in the space between the lavatory and tile.
Install the faucet to the countertop according to the faucet
manufacturer's instructions.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
Kohler Co. 7 1018893-2-C