General Information; Installing Instructions - Glem Gas GHW97BK Manual De Instrucciones

ENGLISH

GENERAL INFORMATION

Carefully read the following important
information regarding installation safety
and maintenance. Keep this information
booklet accessible for further consultations.

INSTALLING INSTRUCTIONS

This hood is prepared to be installed above
a hob by fixing it to the wall. It can be
installed in two ways:
• EXHAUST MODE: the kitchen vapours are
purified by the metal anti-grease filters and
carried outside through a ducting system.
• RECIRCULATING MODE: the kitchen
vapours are purified by the metal anti-
grease filters and an activated carbon filter,
then conveyed back into the kitchen.
We suggest to have installation carried out
by qualified personnel, in compliance with
all the current regulations and in particular
with the ones concerning air exhaust.
The manufacturer cannot be held liable for
damages caused by improper installation
or if it has not been carried out according to
the state-of-the-art.
SAFETY
The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
40cm from electric cookers and 65cm from
gas or mixed cookers. It is possible to install
the hood so that the distance between the
cooking top and the fats filter is not less
than 65 cm in the case of gas or mixed
cookers. If the instructions for installation
for the gas hob specify a greater distance,
this must be adhered to. (Fig.10).
• If a connection tube composed of two
parts is used, the upper part must be placed
outside the lower part.
• Do not connect the cooker hood exhaust
to the same conductor used to circulate
hot air or for evacuating fumes from other
appliances generated by other than an
EN
electrical source.
• Take care when the cooker hood is
operating simultaneously with an open
fireplace or burner that depend on the air
in the environment and are supplied by
other than electrical energy, as the cooker
hood removes the air from the environment
which a burner or fireplace need for
combustion. The negative pressure in the
environment must not exceed 4 Pa (4x10 –5
bar).
• Provide adequate ventilation in the
environment for a safe operation of
the cooker hood. Follow the local laws
applicable for external air evacuation.
• Use screws and screw anchors suitable for
wall (e.g. reinforced cement, plasterboard)
for the mounting of the cooker hood. Where
screws and screw anchors are supplied
ensure that they are suitable for the type
of wall where the cooker hood is to be
mounted.
COMPONENTS LIST > see Fig.2
MOUNTING THE COOKER HOOD TO THE
WALL
• Drill holes A-B-C according to indications
quoted in (fig.3).
• Hang the cooker hood on the wall using
the drill holes A (Fig.5).
• Fasten the cooker hood using the
fastening drill holes B (Fig.6).
• Connect the flange Y of Ø150 mm (fig.2)
to the discharge opening with a connecting
tube.
If the apartment is equipped with an
external Ø120 mm air duct, apply the
reduction fitting provided. (do not carry
out the above instructions for recirculating
mode).
• Thread the upper chimney E to the
inside of the lower chimney F; Insert them
vertically on of the cooker hood body
(Fig.7A).
• Affix the bracket Z (Fig.8) to the wall via
the drill holes C.
• Slide the upper chimney E towards the top,
locking it in with the appropriate screws in
4