Depth Adjustment - Bosch CCS180 Instrucciones De Funcionamiento Y Seguridad

2610046822.qxp_CCS180 3/23/17 1:20 PM Page 11
reduce the risk of starting the tool accidentally.

DEPTH ADJUSTMENT

Disconnect battery pack from tool. Loosen the
depth adjustment lever located on the right
side of the tool. Hold the foot down with one
hand and raise or lower saw by the handle.
FIG. 3
CALIBRATED DEPTH
BRACKET
90° CUTTING ANGLE CHECK
Disconnect battery pack from tool. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on quadrant,
retighten lever and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 5). Make adjustments by
turning the small alignment screw from bottom
side of foot, if necessary (Fig. 6).
BEVEL ADJUSTMENT
Disconnect battery pack from tool. The foot
can be adjusted up to 50° by loosening the
bevel adjustment knob at the front of the saw.
Align to desired angle on calibrated quadrant.
Then tighten bevel adjustment knob (Fig. 7).
Because of the increased amount of blade
engagement in the work and decreased
stability of the foot, blade binding may occur.
Keep the saw steady and the foot firmly on the
workpiece.
Operating Instructions
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
DEPTH
ADJUSTMENT
LEVER
Tighten lever at the depth setting desired.
Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
FIG. 4
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
FIG. 5
BEVEL
ADJUSTMENT
KNOB
BLADE
FOOT
FIG. 7
QUADRANT
-11-
FIG. 6
ALIGNMENT
SCREW
BEVEL
ADJUSTMENT
KNOB