Publicidad
Idiomas disponibles
Idiomas disponibles
- The basic set of screws fits in most of the TV's but, due to the constant design changes with no previous
warning, it may not fit in your equipment.
6
2
1
3
4
- Attach left and right tilting supports on your
Plasma/LCD TV, positioning them vertically as much
centralized as possible.
Note that the edges with rounded orifices must be
facing up.
- Before transferring the holes from the base plate to the
wall, check the height desired for the TV, considering
that the base plate will be totally centered, in relation to
the tilting supports, vertically.
.
- Note that the wing locking nuts of the tilting set (05)
must be turned out, allowing to access them with the
hands after the TV is placed.
5
- After attaching the tilting set on the TV, lock them in a
centralized position tightening both wing locking nuts
(5).
- Loose the fastener screws (6) until its extremity faces
the internal nut.
5
- Transfer the holes of the base plate (1, 2, 3 and 4) to
2
the wall, so that the drilling for its fastening can take
place.
- Note that hole #1 (rounded) must be facing up.
- The oblong holes (2, 3 and 4) allows a slight rotation
adjustment when tightening the fastening screws,
therefore the drilling on the wall must be done as much
centralized as possible.
3
Publicidad
