Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See FIg. A) - Parkside PASSP 20-Li A2 Manual Del Usuario

Safety guidelines for battery
chargers
This tool may be used by children
■
aged 8 years and above and by
persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the tool safely and are aware of the
potential risks. Do not allow children
to use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
To avoid potential risks, if the appli-
■
ance power cable is damaged, it
must be replaced by the manufac-
turer, its customer service or by a
qualified technician.
The charger is suitable
for indoor use only.
WARNING!
■ To avoid potential risks, if the appliance
power cable is damaged, it must be replaced
by the manufacturer, its customer service or
by a qualified technician.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.
PASSP 20-Li A2

Before use

Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery pack
battery charger
♦ Insert the mains plug into the mains power
socket. The green charge control LED
up briefly, then the red charge control LED
lights up.
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
ATTENTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
to the high-speed
(see fig. A).
lights
indicates that the
flashes, this means
has overheated and
both
into the appliance.
GB │ IE
│
is
7 ■