Wall Control Installation; Operating The Fan - HAMPTON BAY 52356 Guía De Uso Y Mantenimiento

Operating Your Fan and Wall Control
Wall Control - Your fan is equipped with a wall control to operate the
speed of your new ceiling fan. For more information on how to install
the wall control, see the wall control instructions packaged with the
wall control components.
The appropriate speed setting for warm or cool weather depends on
factors such as the room size, ceiling height, and number of fans.
The fan is shipped from the factory with the reversing switch
positioned to circulate air downward. If airow is desired in the
opposite direction, turn your fan off, and wait for the blades to stop
turning, then slide the reversing switch (located in the switch cup) to
the opposite position, and turn the fan on again. The fan blades will
turn in the opposite direction and reverse airow.
NOTE: Wait for the fan to stop before reversing the direction of blade
rotation.
Warm weather - (Forward) A downward airflow creates a cooling effect.
This allows you to set your air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
All manuals and user guides at all-guides.com
P12

Wall control installation

WARNING: To avoid possible electrical shock, be sure
electricity is turned off at the main fuse or circuit
breaker box before wiring. Turning off the wall
switch is not sufcient to prevent shock. All wiring
must be in accordance with National and Local
codes, and the ceiling fan must be properly grounded
as a precaution against possible electrical shock.
□
Disconnect the main fuse or circuit breaker box.
□
Remove the faceplate and screws from the existing wall
switch, and pull the switch out from the wall outlet box.
□
Disconnect the wires from the existing fan wall switch.
□
Slide the wall control (I) to the off (0) position.
□
Connect the "black wire (KK) (AC IN)" from the wall
control (I) to the 120V AC wire (KK) with a wire connector
provided.
□
Connect the green/yellow wire (II) from the wall control
(I) to the green wire (II) from the fan with a wire
connector provided.
□
Connect the "black wire (KK) (TO MOTOR)" from the wall
control (I) to the black wire (KK) that feeds the fan/motor
with a wire connector provided.
□
Attach the wall control (I) to the wall outlet box with two
screws provided.
□
Position the faceplate onto the wall control (I) by clicking
the faceplate.
□
Restore power at the main fuse box or circuit breaker
panel.
NOTE: This control is designed to operate only one
ceiling fan.

Operating the fan

Fan slide switch
0 = Power off
1 = High speed
2 = Medium speed
3 = Low speed
12
I
KK
KK
II
II
3
2
KK
KK
1
0