HAMPTON BAY 52356 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (L) from the canopy (C) by turning
the ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws (SS) on the top of the canopy (C).
□
Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting bracket
(A).
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
WARNING: Failure to properly install set screw (GG) could
result in fan loosening and possibly falling.
□
Loosen, but do not remove, the setscrew (GG) on the collar (M) on
top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly (B) with
the holes in the collar (M) on top of the fan-motor assembly (D).
□
Carefully insert the hanger pin (CC) through the holes in the collar
(M) and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrew (GG) on the collar (M) on top of the fan-
motor assembly (D).
All manuals and user guides at all-guides.com
2
A
SS
C
L
7
Routing the wires
□
Route the wires exiting the top of the fan motor (D) into
the decorative motor collar cover (F) and through the
canopy ring (L).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
CC
Please contact 1-877-527-0313 for further assistance.
C
B
F
D
B
F
DD
B
GG
D
HAMPTONBAY.COM