Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The SpO
and Pulse
2
Rate is not displaying
normally
The SpO
and Pulse
2
Rate are not displayed
stably
The device cannot be
turned on
The display has turned
off suddenly
Authorized European Representative: Wellkang Ltd
Manufactured by: Shenzhen Jumper Medical
Equipment Co. Ltd
Distributed by: SHINEMART Ltd.
Troubleshooting
Possible Reason
a.The finger is not
properly positioned.
b.The patient's SpO
too low to be detected.
a.The finger is not
placed inside deep
enough.
b.The finger is shaking
or the patient is moving.
a.Low battery or no
battery.
b.The batteries are not
inserted properly.
c.The malfunction of the
device.
a.The device will power
off automatically when
there is no signal within
16 seconds.
b.The batteries are
almost drained.
14
Solution
a.Place the finger
properly and try again.
is
b.Try again; If you are
2
sure that the device
is working well, seek
medical help for a
diagnosis.
a.Place the finger
properly and try again.
b.Calm the patient and
then try again.
a.Change batteries.
b.Check batteries are
installed correctly.
c.Contact Duronic.
a.Normal.
b.Change batteries.
Publicidad
