Switch Function; Operation Steps - Daitsu ADD12 Instrucciones

Operation
●

Switch function

1. "1/0" switch
Press the switch once to start operation, press it again to stop operation.
2. " "switch
Each time the switch is pressed, the operation mode changes in the order of "DEHUMIDIFY",
"LAUNDRY" and "QUIET" and the corresponding mode indicator lamp will change with the opera-
tion mode.
3. " "switch
Press the switch to set the humidity of the room, which can be set in order of "50%", "60%" "70%" and
"continuous", and the corresponding humidity indicator lamp will lights to display your setting humi-
dity. When the relative humidity of the room is lower than your setting humidity, the operation will stop
automatically. After the operation is started, the default operation mode is the continuous mode, the
operation is continuous in the continuous mode until the unit is stopped or automatically stopped for
the drainage tank is full.
Operation
●

Operation steps

1. Plug the power supply plug into the outlet and press the "1/0" switch
2. Open the louver by hand
AC
220~230 V
• Use single phase 220~230V AC power supply.
• Wipe dust off of the power supply plug and insert
the plug firmly, all the way to the rubber section,
if there is a dust on the plug, or the plug is not
fully inserted in the outlet, electrical shock and/or
fire may result.
• Never scratch, cut, or damage the power supply cord.
• After the power supply plug is plugged into the
outlet, " " lamp will light.
• Before operation runs, please check and make
sure the louver has been opened, or it will result
in the temperature of the unit too high and cause
accident. (There are 6 levels to be chosen.)
53