Daitsu ADD12 Instrucciones página 57

Operation
Drainage steps
2. Discard the water
Guard
3. Place back the drainage tank
Operation
●
Draining the water
Continuous drainage of water
The unit has a continuous drainage port. Using a commercial hose (with an inner diameter of 15mm),
the water in the drainage tank can be continuously drained out of the continuous port of the unit.
When setting up the equipment for continuous drainage, always stop operation first and unplug the
power supply plug.
Drain water
from this point
1. Disconnect the drainage tank and open the continuous drainage port.
Use nippers or a similar tool to cut away the continuous drainage
port in the side of the main unit.
2. Push the hose into the continuous drainage port.
Pass a commercial hose (with an inner diameter of 15mm) through
the continuous drainage port, and press it firmly into the drainage
port in the main unit, make sure water does not leak. The level
height of drain piping should always be not higher than the one of
the drainage port, also drain piping should always be not plugged
up, so the condensed water can be drained out successfully.
3. Return the drainage tank to its original position.
Check the hose periodically to make sure it is still connected and has
not been obstructed.
Notation for drainage
●
When place back the drainage tank, press the
tank firmly into place with both hands. If the
tank is not positioned properly, the "Tank Full"
sensor will be activated, and the dehumidifier
will not operate.
Check to make sure the guards are firmly atta-
ched to the tank. If they are not, the drainage
tank will be harder to remove.
●
If the drainage tank is removed while the unit
is in operation, or immediately after operation
has stopped, water which is still in the cooling
unit may drip out on the base plate. Wait at
least 30 minutes before removing the drainage
tank. (If water has dripped, wipe it up.)
55