Candy CDJ642KTT Manual De Instrucciones página 14

Using the Power Management
Using power management you can set the total power to 2.5kW/ 3.0kW/ 4.5kW/
6.5kW and 7.4kW. The default total power setting is the maximum power level.
Setting the total power level to fit your requirement
1. Make sure the cooktop is turned off.
Note: you can only set power management when the cooktop is turned off.
2. Touch the button "Stop + Go" and hold for 5 seconds. You can hear
the buzzer beeps one time.
3. After you hear the beep, touch "+" and "-" button at the same time and hold for
3 second, the timer indicator will show flashing previous total power level, e.g.
'2.5'. Touch and hold " +" and "-" for 1 second again to switch to other power level,
for example 3.0. When the power that you want is flashing, touch the button
"Stop+Go" and hold for 5 seconds. The buzzer will beep 10 times. It means you
have finished the setting.
Note:
1. After step 2, you must touch the "+" and "-" within 3 seconds after you hear
the beep. Otherwise you will need to start again from step 2.
2. Once finish setting, wait till the end of 10 beeps. Do not touch any button during
this period. Otherwise the setting will be invalid.
Power management Rules
If total power exceeds the limitation of 2.5kw, 3.0kw, 4.5kw, 6.5kw (depending
on which level you've set), you are not able to increase power stage of any zone.
If you increase it by touching '+', the cooktop will beep 3 times and indicator will
show a flashing 'Pn'. Thus you need to decrease power stage of other zones before
increasing the power of objective zone.
EN-13