Operating Instructions; On/Off; Speed Control; Breaking Control - e-TWOW S2 ECO Instrucciones De Uso

2. Operating Instructions

a)

ON/OFF

Press the switch for 1 sec, and the display will light up, indicating that the power is on. Press for 3
seconds if you want to turn it off. The scooter will turn off if you don't use it for more than 3 minutes.
b)

Speed control

Press the right thumb lever accelerator to control the speed (1-30 km/h).
c)

Breaking control

Press the left thumb lever and the electronic magnetic brake will be activated. The more you
press, the greater the braking force will be.
d)

Horn

If you turn on the power, when pressing the horn button, it will honk.
e)

LED headlight

In manual mode: Press the ON/Off light button when needed and there will be a sign in display
indicates the light is turned on. Press the button again when you do not need the light. Keep
pressed for a few seconds.
The scooter is equipped with a sensor light that detects the need of light. The light will turn on
automatically (auto light mode) if the sensor detects poor ambient light.
For example: when is cloudy weather and the auto light mode is on, the light turns on. If the
daylight is proper, the auto light mode detects the light and the headlights will go off after 5
seconds.
On auto light mode, the display is also lighted depending on the ambient light.
If the scooter is on auto light mode, you can go to manual mode by pushing the ON/Off light
button until the sign "Auto" disappears from the screen.
f)

Mileage Show

When the display is powered, it displays 2 modes: total and trip. You can navigate between
"Total" and "Trip" by pressing the settings button. In 'trip' mode, press the setting button (S) for 3
seconds and it will reset the trip mileage to 0.
g)

Emergency braking

In case you need fast braking, it's recommended to use the foot brake.

3. Display factory settings

For E-TWOW models manufactured before 01.01.2016, please see the instructions below:
To access the menu P0 and P1 please press at the same time the switch and setting buttons.
Pressing the setting button helps you switch between P0 and P1.
Both menus have other two sub-menus : 0 and 1, as follows:
P00 (a) - displays the speed in km/h and temperature in Celsius degrees
P01 (b) - displays the speed in mile/h and the temperature in Fahrenheit degrees
P10 (c) - lights are set on manual mode
P11 (d) - lights are set on auto mode
You can switch between menus 0 and 1 in P0 or P1 by pressing the on/off button.
When you press the setting button (S) at last and the settings will be finished.
All manuals and user guides at all-guides.com
8