Philips SpeedPro FC6728/82 Manual Del Usuario página 11

English
14
Problem
The bottom segment of
the display flashes red.
All segments of the display
flash quickly.
The water flow from the
water tank is reduced.
The output of water is
faster and larger than
normal.
The floor dries with stripes
when I use the water tank.
Possible cause
The battery is empty.
An error has occurred.
The wetting strip is blocked
by excessive residue.
The microfiber mopping pad
is not placed correctly and
blocks the wetting strip as a
result. This prevents water
from flowing out of the
wetting strip.
The water tank is empty or
nearly empty.
You use a microfiber
mopping pad that is not
supplied by Philips.
If the water tank produces an
uncontrolled and too large
amount of water, the cap of
the tank is probably not
closed properly.
The strip is not placed
properly in the bottom of the
water tank.
You added too much liquid
cleaner to the water.
Solution
To charge the battery, connect the
appliance to the charging base or attach
the handheld vacuum cleaner directly to
the magnet on the charging base.
First try to recharge the appliance,
empty the dust container and clean the
filter. If this does not help, take the
appliance to a Philips service center or
contact the Consumer Care Center via
www.philips.com/support.
Remove the wetting strip and clean it.
Make sure that you place the mopping
pad correctly. Check the user manual for
proper placement.
Refill the water tank.
Only use an original Philips microfiber
mopping pad. You can buy these
mopping pads in the online Philips shop
at www.philips.com/parts-and-
accessories or at your Philips dealer. You
can also contact the Philips Consumer
Care Center in your country (see the
international warranty leaflet for contact
details).
Check the cap and make sure it is fully
and properly closed.
Check the strip and make sure that it is
fitted properly in the bottom plate of the
water tank.
Use only a few drops or use a cleaner
that foams less.