GB
5. Connecting the brush and the angled injector.
These two attachments can be applied to the (cleaner's) jointed injector, the straight injector and the extension
hose. Chose the desired angle and then press the attachment into the hexagon-shaped end of the injector.
6. Connecting the glass-cleaning attachment.
CAUTION: Do not use the glass-cleaning attachment on cold glass, as this can break the glass.
First connect the fabric attachment to the cleaner or the extension hose. Remove the cloth from the fabric
attachment. There are two open clips on the rear edge of the fabric attachment and two hinges on the rear edge
of the glass-cleaning attachment. Place the hinges on the open clips and then swing the glass-cleaning
attachment upwards towards the bottom of the fabric attachment until the two parts connect. To remove the
attachment, press your thumb against the glass-cleaning attachment's grip. The two parts will separate.
Turning on your Gun
7. Plug the product into a mains socket.
The operating indicator lamp will light. The steam will be ready after approximately 3 or 4 minutes. Watch the
cleaner continuously while you wait. Press the steam production button to release steam. As soon as the Steam
Gun produces steam, start to use it, passing it smoothly over the surfaces to be cleaned. This is the best method
for thoroughly cleaning the surfaces. To disinfect specific areas, hold the Steam Gun over the point, no more
than 2 centimetres from the surface, and move slowly over the surface.
WARNING: Never place the portable steam cleaner upside down when it is being used nor aim it at people, animals
or plants. Pressurised tank: Do not open the filling cap during use.
8. Filling the Steam Gun when it has run out of steam.
Unplug the cleaner. Press the steam production button until all the pressure has been released. Wait
approximately 5 minutes before carefully unscrewing the safety cap. Slowly turn half a turn and wait until the
whistle of the remaining steam leaving has stopped. Fully unscrew the cap and leave to cool. Slow pour one
measure of the measuring container (included) in the container using the funnel (included) (350 cc). Do not
overfull. Rescrew the safety cap onto the cleaner. Plug the cleaner into the mains socket and it will start to
produce steam again.
WARNING: This unit operates under pressure. After each use, press the steam production button until all the
pressure has been released before removing the safety cap.
Cleaning and Maintenance
NOTE: You must unplug the product from the mains and leave to cool before performing any cleaning and
maintenance task.
- Allow the product to fully cool before cleaning or putting it away.
- Empty any water remaining in the heater after each use.
- Store in a cool, dry place.
To guarantee a long, trouble-free service life, rinse the heater with water once a month to remove any scale. Do not
use vinegar or any other descaling substance. With the gun unplugged and cold, pour in one measure of water,
replace the safety cap and shake to remove any scale. Remove the safety cap and pour out the water immediately
into a sink. CAUTION: Do not immerse the product in water.
Suggested uses for the attachments
Brush
Stove tops, joins between tiles, inside of rubbish bins.
Fabric attachment
For steam-cleaning cloths, upholstery, curtains. It is recommended that you use the hose and the cloth with the
fabric attachment when used for clothing, upholstery and curtains.
Glass cleaner
Windows, glass panes, glass doors. Do not use when the glass is cold, it may break.
Straight injector
Edges, windows, sills, cornices, tiles, mantelpieces.
Angled injector
Places that are difficult to reach, WCs, windows, sills.
12
All manuals and user guides at all-guides.com