Air Conditioner Features; Electronic Control Operating Instructions - Daitsu APD12-AN Manual De Usuario

AIR CONDITIONER FEATURES

Electronic control operating instructions

Before you begin, thoroughly familiarize yourself with the control panel and remote controller and all its
functions, then follow the symbol for the functions you desire.
The unit can be controlled by the unit control panel alone or with the remote controller.
NOTE:
This manual does not include Remote Controller Operations, see the <<Remote Controller Instruction>>
packed with the unit for details.
Operation panel of the Air Conditioner
(The model has no auto swing feature
without this button)
A U TO C O O L
H E AT D R Y
FA N
Fig. 4
• MODE select button
Selects the appropriate operating mode. Each
time you press the button, a mode is selected in
a sequence that goes from AUTO, COOL, DRY,
HEAT (cooling only models without).The mode
indicator light illuminates under the different
mode settings
Fig, 4.
• TIMER button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjunction
with the  &  buttons.
• POWER button
Power switch on/off.
• SLEEP button
Used to initiate the SLEEP operation.
• FAN button
Press to select the fan speed in four steps-LOW,
MED (on some models), HIGH and AUTO.
The fan speed indicator light illuminates under
different fan settings except AUTO speed. When
select AUTO fan speed, all the fan indicator
lights turn dark.
9
6
7
S W I N G
F
T I ME R O N
M O D E
T I ME R O F F
2
1
Remote signal receptor (Some models
have the signal receptor on the front
panel, Fig.2)
8
6
I O N
C
S L E E P
3 4
• Up ( ) and DOWN () button
Used to adjust (increasing/decreasing)
temperature settings (1ºC/2ºF increments) in
a range of 17ºC (62ºF) to 30ºC (88ºF) or the
TIMER setting in a range of 0~24hrs.
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time, for 3 seconds.
• LED Display
-Shows the set temperature in "ºC" or "ºF" and
the Auto-timer settings. While on DRY and FAN
modes, it shows the room temperature.
Error codes:
E1- Room temperature sensor error - Unplug the
unit and plug it back in. If error repeats, call for
service.
E2- Evaporator temperature sensor error - Unplug
the unit and plug it back in. If error repeats, call
for service.
E4- Display panel communication error - Unplug
the unit and plug it back in. If error repeats, call
for service.
P1- Bottom tray is full - Connect the drain hose and
drain the collected water away. If error repeats,
call for service.
H I
M E D
FA N
LO W
5
44