Plantronics VISTA M12 Manual Del Usuario página 8

INSTRUCTIONS
GB
A
CONNECTING THE ADAPTER TO YOUR
TELEPHONE AND HEADSET
Unplug the handset coiled cable from the telephone base and
plug it into the port labelled with the handset symbol on the
Adapter.
the telephone symbol into the handset cord port on your
telephone.
Disconnect™ (QD) connector together. Your headset and
Adapter are both supplied with QD connectors. (See diagram).
your headset.
before installing the Adapter. Your telephone may have a special
socket labelled headset; if this is the case do NOT connect the
handset to the Adapter. Please check your telephone user guide
to find out how to set up headset operation on your telephone.
B
ADJUSTING THE ADAPTER
The Adapter has been designed to work with most telephones.
The following instructions will help you to set up your Adapter
with your telephone. Most telephones will work with the switch
set in position 5. If this does not work try the other positions.
INSTALLING BATTERIES
The batteries on your Adapter may need to be installed before
you can use your headset. You should disconnect your
telephone from the network before doing this.
of the Adapter by pressing on the grips and pushing down.
inside of the battery compartment, and replace the cover.
2
Insert the coiled cable from the Adapter port labelled with
To connect your headset, put the 2 halves of the Quick
Refer to your headset user guide for further information on
Note: The telephone must be disconnected from the network
To install the batteries, remove the battery cover on the side
Put the batteries into the compartment as shown on the