Fan Assembly - Proline VP40 Manual De Instrucciones

Ventilador de pie 16"
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
6. Insert the internal pole into the control box then
fasten the screw to securely a ach the pole to the
control box.

FAN ASSEMBLY

Make sure the fan is disconnected from the mains socket.
Rear guard assembly
Unscrew the retaining nut from the motor spindle clockwise. Unscrew the locking
nut from the fan motor.
Pos on the rear guard onto the motor housing; make sure the handle on the rear
guard is poin
upwards.
Insert the locking nut and turn it clockwise to lock the rear guard into
Fan blade assembly
Slide the fan blade onto the motor spindle, making sure the motor spindle is fully
seated into the blade groove.
Screw the retaining nut an
Front guard assembly
Remove the small securing screw and nut from the front guard.
Make sure that the holes in both guards are aligned and fasten them securely using
the provided screw and nut. Once the guard is in posi on fasten the clips to
secure both guards.
OPERATION
1. Place the fan on a stable, level surface.
2. Plug the fan in the mains socket.
3. Press the speed bu on to 1, 2 or 3 to select the desired speed. To turn o the fan,
simply press bu on 0.
0= O
1= Low speed
4. To make the fan oscillate, push down the oscilla on knob located on the top of
the motor housing and the fan will oscillate from side to side.
To stop the fan from oscilla
5. Ti
Adjustment
The
ow can be adjusted upward or downward by stepping on the base and
then pushing the guard up or down as required.
to
hten the fan blade to the motor spindle.
2=Medium speed
3=High speed
g,
up the oscilla
3
knob.
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido