Intended Use - Worx Professional WU253 Manual Del Usuario

Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point
All manuals and user guides at all-guides.com
8
Operating instructions
Note: Before using the tool, read the instruction book carefully.

INTENDED USE

The power tool is intended for driving in and loosening screws as well
as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the Battery Pack(6) may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the Battery Pack is charged for the first time and after
prolonged storage, the Battery Pack will accept a 100% charge after
several charge and discharge cycles.
B) TO REMOVE OR INSTALL BATTERY PACK (See Fig. A)
Locate latches on side of Battery Pack and depress both sides to
release Battery Pack from your tool. Remove Battery Pack from your
tool. After recharge insert the Battery Pack into the battery port. A
simple push and slight pressure will be sufficient.