Environmental Protection - Worx Professional WU253 Manual Del Usuario

8
FULLY AUTOMATIC SPINDLE LOCKING (AUTO-LOCK)
(See Fig. F)
The screwdriver Bits Holder (10) is locked when the On/Off Switch
(8) is not pressed.
This enables screws to be screwed in, even when the battery
is empty and allows for the machine to be used as a manual
screwdriver.
Important: When using as a manual tool, do not press the On/Off
Switch (8). Otherwise the screwdriver can be damaged.
9
USING THE LED LIGHT
To turn on the light simply press the on/off switch. When you release
the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed area. LED is
also a battery capacity indicator. It will flash when power gets low.
10
DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of
the battery pack properly. This battery pack contains Lithium
batteries. Consult your local waste authority for information
regarding available recycling and/or disposal options. Discharge
your battery pack by operating your tool, then remove the battery
pack from the tool housing and cover the battery pack connections
with heavy-duty adhesive tape to prevent short circuit and energy
discharge. Do not attempt to open or remove any of the components.
11
OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the
machine immediately and allow cooling for approx. 30 seconds at the
highest no-load speed.
All manuals and user guides at all-guides.com
12
13
10
TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject
to overload. When the load is too high or the allowable battery
temperature of 75°C is exceeded, the electronic control switches off
the power tool until the temperature is in the optimum temperature
range again.
PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the
"Discharging Protection System". When the battery is empty, the
machine is switched off by means of a protective circuit: The inserted
tool no longer rotates.
Maintenance
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.

Environmental protection

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.