Maico easyTymp Guía De Referencia Rápida

Quick Reference Guide – easyTymp™
Powering the Unit
1. Press the RED or BLUE ARROW
to turn the unit ON.
2. The test will default to the protocol last
selected.
3. Press and hold the RED and BLUE ARROWS
together to turn the unit OFF.
Conducting a Test
1. Press SELECT TEST
screen.
2. Use UP and DOWN ARROWS
desired test protocol.
3. Press SELECT on the right side of screen.
4. Select test ear using the RED (RIGHT) or
BLUE (LEFT) ARROW keys.
5. Test will start when probe is placed in the
ear. Status of the test is shown at the top
of screen.
6. When test is finished, use UP or DOWN
ARROWS to scroll through screen and
review results.
MAICO Diagnostics
1162-1101 Rev B
on left side of
to highlight
Printing Test Results to Thermal Printer
1. To print results on the built-in thermal
NOTE: If results do not print automatically,
press the PRINT button. (Manual or automatic
printing can be selected in the set-up menu.)
Saving Test Results to NOAH Module
1. Make sure cradle is connected to computer
2. Open MAICO Impedance module via NOAH
NOTE: Upon initial set-up of the software, click
on EXTRAS and select SETTINGS. Select USB
(easyTymp Communicator). Then click OK.
7625 Golden Triangle Drive, Eden Prairie, MN 55344
NOTE: If "show pass/fail" is turned on in
the set-up, a √ (check mark) indicates a
pass, and an X indicates a refer result.
printer, place the unit in the cradle. Results
should print automatically.
via USB cord.
database.
3. Place unit in cradle to download test
results.
NOTE: If results do not download automatically,
click REQUEST MEASUREMENT at top of
software module screen.
Set-Up Menu
1. Press SELECT TEST
2. Press EASYTYMP.
3. Scroll with UP and DOWN ARROWS
highlight a Set-up Menu selection.
4. Press SELECT.
5. Use UP and DOWN ARROWS
6. Press RIGHT or LEFT ARROWS to change
selection.
7. Press SAVE to save all changes and exit back
to Set-up Menu screen.
8. Press BACK to exit back to protocol list.
Tel: 888.941.4201 www.maico-diagnostics.com
.
to
to scroll.
04/12