Features; Get To Know Your Gear - GOAL ZERO 10 AMP Guia Del Usuario

Features

• Advanced MCU control pulse width modulated (PWM) technology, high efficiency.
• Target for LiFePO4, LTO (Lithium Titanium Oxide), Gel, AGM, Conventional lead-acid
(WET) and Calcium Batteries.
• Built in regulator to prevent your battery from being overcharged. Overcharging occurs
when the charge voltage is unregulated. This can result in premature battery failure.
• Comes with a regulator to prevent undercharging of your battery - a condition that is
very common in solar charging but especially with conventional lead-acid or calcium
batteries. The unit provides an automatic Equalization feature for deeply drained
Conventional lead acid battery or Calcium battery, as well as provides a cycling
automatic Equalizing feature every 28 days.
• Can be connected to the battery permanently to keep the battery fully charged by using
a process called "floating". This means the controller will stop charging when the battery
is full and will automatically start charging the battery as required. This process will also
reduce water loss and help prevent the battery from ' d rying out' .
• Protects your battery from discharge at night. Under low light or no light conditions the
solar panel voltage could be less than the battery voltage. The unit contains a special
circuit which prevents current flowing back from the battery and into the solar panel.
• Colored LED's to easily indicate the operational status and battery conditions.
• Digital LCD to directly display battery voltage, charging current, charging capacity (Amp
hour), battery types and fault codes.
• Provides external battery temperature sensor (Requires additonal wires - not included).
• Multi charging protections against reverse polarity, short circuit, over temperature, over
voltage, etc.
• Surface Mount, Flush Panel Mount or Portable solar kits Mount options.
• Conformal-coating circuit boards and plated terminals for inclement weather.
2

Get To Know Your Gear

The Goal Zero 10A Charger Controller is used to connect Goal Zero Solar Panels directly
to external batteries. The Charge controller connects Goal Zero Solar Panels to 12V
battery (AGM, LiFePO4, LTO, Gel, Lead Acid, and Calcium Batteries) to charge and
monitor the charging of the battery. Perfect for RV'S, motorcycles, snowmobiles, tractors,
watercraft, lawnmowers, cars, etc.
Note:
• Will not work with Nomad 5,7,7+,and 10.
• Optional SAE to Ring terminal and SAE to Alligator Clips sold separately
3