Kohler K-6890 Guia De Instalacion página 4

2. Install the Frame to the Wall
Construct 2x4 stud framing. Install double 2x4 bracing
horizontally between the vertical studs where the table will be
installed. Refer to the roughing-in information.
Completed the finished wall.
Mark and drill two 1/4" (6mm) holes through the finished wall
and into the horizontal bracing. The holes should be 16" (40.6cm)
apart and 31-7/8" (81cm) up from the floor. Install two hanger
bolts to the horizontal bracing using the drilled holes.
Position the frame against the wall so the slots in the back panel
are over the hanger bolts. Loosely assemble a washer and acorn
nut to each hanger bolt.
Insert a leveler into the bottom of each leg.
Securely tighten the acorn nuts.
Level and square the legs and frame, and rotate the levelers in a
clockwise direction until the frame is level.
1002313-2-A 4 Kohler Co.