Technical Data; Safety Instructions - Toparc PRO 600L Guia Del Usuario

Translation of the original instructions
OPERATING INSTRUCTIONS

TECHNICAL DATA

Light Source
Luminous Power
Operating time
Battery Specification
Charging Time
Charging Input
Degree of protection
Operating temperature
WARNING
• Do not open the device.
• Do not look directly into the light emitting lamp - Risk of eye injuries!
• Do not operate in direct sun light or extreme temperature conditions.
• Operating temperature, -10°C to +40°C.
• Keep away from children! Children should be supervised in order to ensure that they do not play with the device!
OPERATING & CHARGING PROCEDURE
• LED PORTABLE LAMP Operating mode as below
- Press the Switch first time, top light switch on.
- Press the Switch third time, main light switch to ECO mode.
- Press the Switch second time, main light switch to full power mode.
- Press the Switch fourth time, whole light switch off.
• Switch lamp off and put light onto the base, and connect with USB charger during charging. The charging port on
the side could be used when the charging base is not available.
• The LED of the indicator switches to red during charging.
• If charging is completed, green LED illuminate will turn on.
• If the battery indicator did not light up, please remove the charger and try again.
• Always only use the charger recommended by to charge the lamp.
The use of a NON-recommended charger can lead to a fire and destroy the lamp.
• Before taking the hand lamp into service for the first time charge it for 4-5 hours.
• Fully charge the hand lamp before it is stored for a longer period.

SAFETY INSTRUCTIONS

• Do not use the device if there is damage to the housing, plug or cable. Consult your local authorized specialist!
• Do not open the device! Repair work and replacing the rechargeable battery pack may only be carried out by electri-
cians.
• Carry out cleaning tasks only when the mains plug is removed from the mains power!
• There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned and trained persons.
Please contact your nearest authorized branch.
• Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and moisture. Danger of
explosion.
• If the battery is damaged or not used correctly. Fluids can leak from the battery. Avoid contact with these. Leaking
battery fluids can lead to skin irritation or burns. Rinse off with water if you should come into contact. If the fluid
gets into your eyes,make sure you get medical help.
• The lamp is not allowed to be placed on the light surface while being switched on.
4
PRO PORTABLE LAMP 600L
Keep this instruction manual for future reference or for subsequent possessors.
high power COB LED ‒ Main light
high power SMD LED ‒ Top light
ca. 600 lm ‒ Main light full power mode
ca. 200 lm ‒ Main light ECO mode
ca. 100 lm ‒ Top light
ca. 1.5h ‒ Main light full power mode
ca. 4.5h ‒ Main light ECO mode
ca. 10h ‒ Top light
Li-Ion 3.7 V, 2600 mAh, 9.62 Wh
ca. 4 h
DC 5V 1A
IP 54
‒10 °C to +40 °C
EN