Using The Headphones - Silvercrest SBKP 1 A1 Instrucciones De Utilización Y De Seguridad

Using the headphones

Connect the headphones to a communication device.
Place the headphones near a switched-on communication device (e.g. cell
phone or computer).
Pairing with a new Bluetooth device: Hold the button for 6 seconds
®
3
until the LEDs flash red and blue and an acoustic signal sounds. This in-
2
dicates the headphones are now in pairing mode, which remains active for
5 minutes. The headphones will switch off if they do not detect a Bluetooth
®
device to connect to and sound 4 beeps.
Now connect your communication device (cell phone or computer) with
the headphones via Bluetooth . Please refer to the notes in the instructions
®
for your communication device. Select the entry "SBKP 1 A1" from the list
of devices detected by your computer or mobile.
Once the connection has been established, the LEDs will briefly flash blue
twice every 3 seconds.
Please note, your communication device must support Bluetooth Standard
®
4.0 to use all options.
If you come into range of the paired device with the headphones switched
on, a Bluetooth connection will automatically be established.
®
You may need to approve the connection on the communication device.
Please refer to the instructions for use of the communication device on this
topic!
If you leave the range of your communication device with your headphones,
the LEDs will flash blue once every 2 seconds. If the connection is not re-
stored within 5 minutes, the headphones will switch off.
The headphones may be manually switched off by holding the button
for 3 seconds until an acous tic signal sounds and the LEDs go out.
3
US-EN 13