Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step
1. Position the
4
2. Use a
Hex Wrench D
Guard Rail
3. Position the
should be decided prior to attaching the
4. Use the
Hex Wrench D
Guard Rail
).
2
5. Use the
Hex Wrench D
in the interior of the lower
6. Screw the
1" Wood Screw E
the
Short Guard Rail Figure 3
Long Guard Rail
7. Use the
Hex Wrenches D
to cover the unused holes in the cleat that is attached to the
Figure 3
Figure 4
ID #
C
Connecting Nut 1/4" x 17mm
ID #
D
5mm Hex Wrench
ID #
E
1" Wood Screw
ID #
H
Connecting Bolt 5/16" x 2"
All manuals and user guides at all-guides.com
onto the
Long Guard Rail
( ) to tighten the
and into the
Bed Ends Figure 1
Short Guard Rail
onto the
( ) to tighten the
(opposite side of the Ladder opening) into the
( ) to tighten the
Loft Bed Figure 4
( ) through the predrilled holes located on the back side of
(
).
should be placed against the wall.
( ) to install the
H
Figure 2
Hardware Used In This Step
Qty
3
Qty
2
Qty
1
Qty
3
as shown.
Bed Rail
Connecting Bolts H
( ) to each end of the
(
).
Bed Rail Note
.
: The position of the ladder
Short Guard Rail
( ) to one end of the
Connecting Bolt H
Connecting Bolt K
( ) to cover the unused holes
(
).
Note:
If the
Bunk Bed
Connector Bolts I
( ) and
ID #
I
Connector Bolt 1/4" x 18mm
This quantity of the hardware is for the 3/3 Loft Bed
ID #
K
Connector Bolt 5/16" x 18mm
This quantity of the hardware is for the 4/6 Loft Bed
ID #
K
Connector Bolt 5/16" x 18mm
Long
.
Short
Bed End
as shown (
Figure
is placed next to a wall, the
Connecting Nuts C
Cork Panel Figure 5
(
).
Figure 1
Figure 5
Page 7
( )
Qty
3
Qty
8
Qty
12
Publicidad
Tabla de contenido
