Lineout Operation; Important! Transporting The System; Replacing The Stylus; Care Of The Wood Panel And Dust Cover - 1byone 471us-0001 Manual De Instrucciones

NOTE
1.The next time you turn on the device it will automatically connect to the last
EN
Bluetooth playback device connected. If your Bluetooth playback does not
automatically reconnect to the device, you will have to re-establish the connection
DE
to your Bluetooth device manually.
2.If you use a smart-phone as your Bluetooth playback device, the audio file will
FR
muted when there is an incoming call. Acceptance/termination of the call is carried
ES
out via the smart phone. After finishing the call, the playback will be automatically
continued.
JP

LINEOUT OPERATION

IT
1.This system includes a set of LINEOUT jack which allow you to play from the
BT,USB-MP3 and PHONOGRAPH of this system to an external playback device.
2.Insert the audio cable (not included) into the matching "LINE OUT" socket
of the unit.
3.Operate the unit as usual.
4.In order to achieve best effect in sound, advise setting the unit volume into
minimum level.
5.Through the speakers of external playback devices, we can hear the sound
exported from the unit.

REPLACING THE STYLUS

It's suggested to replace the stylus after playing more than 400 hours.
Please follow below steps to change the stylus:
1.Lift the tone arm off the tone arm lock.
2.At the front end of the tone arm, place the tip of your fingernail between the red
stylus holder and the black cartridge housing as shown, press down on the red
stylus holder until it separates from the cartridge housing.
3.Completely remove the red stylus holder with worn stylus and discard it.
4.Place the new red stylus holder with stylus under the cartridge housing. First, press
upward on the back side of the stylus holder, and then press up on the front edge
of the stylus holder until it snaps into place on the cartridge housing.
All manuals and user guides at all-guides.com
07
5.Through the speakers of external playback devices, we can hear the sound
exported from the unit.
IMPORTANT!
TRANSPORTING THE SYSTEM
1.To protect the turntable form the damage during transportation, a sliver transit
screw is located the upper right the turntable platform.
2.Before playing, please use a screwdriver to turn the transit screw in clockwise
direction(screw going down) completely to unlock the turntable.
3.To lock the turntable again for transportation, please turn screw in
counter-clockwise direction.

CARE OF THE WOOD PANEL AND DUST COVER

1.Care of the unit is the same as any piece of of furniture.
2.When the dust cover is dusty, you may wipe it using soft, non-abrasive dust cloth.
3.If the wood panel becomes smudged with fingerprints, you may use any good
quality commercial dusting and polishing a spray cleaner.
4.We recommend spraying the cleaner on the cloth, not directly on the
wooden panel.
08
EN
DE
FR
ES
JP
IT