Use; Turning On And Off - Favero Electronics FA-15 Instrucciones De Instalación

Powering with a POW ER BA N K (accessory)
FA-15 can be powered using the P OW ER BA NK accessory (art. 268-20). It is also possible to use an
alternative non-Favero Electronics POWER BANK with the following specifications:
• USB-out port: current ≥ 2A
• max. dimensions: 130 x 80 x 25 mm (if you want to install it on the back of the FA-15).
For installation:
1. apply the VELCRO® (1) provided to the POWER BANK (2) and to the rear of the FA-15 device,
leaving it for at least 24 hours before applying one to the other;
2. connect the USB power cable (3), installed on the back of the FA-15 panel, to the P OW ER BA NK
( 2 ) .
Fig. 5 Powering with a power bank
When the FA-15 device is switched off, power consumption is minimal and the P OW ER BA NK
may switch itself off. To reactivate it, simply press the button on the P OW ER BA NK.
Disconnect the POWER BANK from the FA-15 device when it is not in use.

3. USE

3.1. Turning on and off

To turn the FA-15 device on/off:
• press the [ON/OFF] key on the remote control or on the app
or
press the [REMOTE] button on the front of the FA-15 panel to switch it on, or hold the button for 5
•
seconds to switch it off.
Note
• When switched on, the display with present the message "txx", where "xx" indicates the
firmware version for which a card attached to the device indicates compliance with FIE
regulations.
• Switching off is indicated by a red LED status light ("Fig. 1" on page 6). When switched off
(stand-by), radio communication remains active.
WARNING
If it is necessary to switch off the device for long periods, remove the power supply unit from
the power socket.
FAV E RO E L EC T RO NIC S
2
- 0259-1060 - FA-15 User Manual - Rev03
3 1
E NG LISH
13
/ 92