Rear spacers
In the appliance, there are two spacers
which must be fitted as shown in the
figure .
Slacken the screws and insert the
spacer under the screw head, then re-
tighten the screws.
Door reversibility
Before carrying out any operations,
remove the plug from the power socket.
To change the opening direction of the
door, proceed as follows:
• To carry out the following operations,
we suggest that this be made with
another person that will keep a firm
hold on the door of the appliance
during the operations.
• Open the door with the appliance in
the upright position. Unscrew the
screws and remove the upper door
plastic trim.
• Remove the little plastic cover from
the door plastic trim and refit on the
opposite side (d).
• Lay down the appliance back side
down.
All manuals and user guides at all-guides.com
• Remove the screw of the hinge cover
• Unscrew the upper hinge and remove
• Unscrew the screw and remove the
• Remove the door.
• Remove using a tool the cover (e)
• Reinsert the cover (e) on the
• Reinsert the door .
• Pay attention that the front board of
plug (a).
it (b).
door stopper (c).
a
unscrew the lower hinge pivot (f)
and place it on the opposite side.
opposite side.
the door is parallel to the front
board of the top.
electrolux 47
b
c