Nailer Operation - Metabo HPT NR 83A5 Instrucciones Y Manual De Seguridad

English
2
Nails

NAILER OPERATION

Read section titled "SAFETY" (pages 4 – 8).
DANGER
Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
Only person who have read
and understand this MANUAL
should operate the Nailer.
NEVER point tool at yourself
or others in work area.
Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
Know and understand what trigger system
you are using.
Please read and understand "Methods of
Operation" below.
18
000Book̲NR83A5̲US̲metabo.indb 18 000Book̲NR83A5̲US̲metabo.indb 18
1
2
Nail Feeder (A)
Nail Feeder (B)
Nail Stopper
3
MUST wear safety
Inspect the Nailer before operating to
determine actuation system.
Before starting work, check the nailing
operation switching device.
This metabo HPT nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
Never place your hands or body closer than 8
inches (200 mm) from fi ring head when using.
Do not drive nails into other nails; nails can
ricochet and hurt someone.
Do not actuate Nailer unless Nailer is placed
fi rmly against the workpiece.
When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
Never use Nailer which is defective or
operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) elevating, lowering or otherwise moving it
to another location;
4) handing it to another person;
5) When removing the lock pin.
6) changing switching device;
7) performing any maintenance or repairs;
8) clearing a jam;
9) Nailer is outside of the operator's
supervision or control;
10) removing nails from the magazine;
11) adjusting nailing depth; and
12) attaching or removing the nose cap.
13) When installing or removing the hook
14) When a xing the hook
2018/05/22 13:58:56 2018/05/22 13:58:56