Mounting The Switch - Tripp-Lite NFI-U05 Manual Del Usuario

DIN-Rail Mounting and Dismounting Instructions
ATTENTION: The NFI-Series switches are open-type
devices and shall be DIN mounted or wall mounted (NFI-U05
and NFI-U08-1 only) in a rack enclosure. The ambient
temperature should not exceed 75°C (167°F).

Mounting the Switch

Place the switch on the DIN rail from above using the built-in slot. Push
the front of the switch toward the mounting surface until it snaps into
place. You will hear a "click" to indicate it has successfully snapped into
place.
Dismounting the Switch
Press the switch from the top, then pull out the lower edge of the switch
to remove it from the DIN rail.
Mounting the Switch
Push
Click
Removing the Switch
7
Push
Click