Powering The Hub - Tripp-Lite U460-4A3C-IND El Manual Del Propietario

Powering the Hub

Power Terminal
A 2-wire terminal block is installed on the unit to power the hub via power
terminal.
DC-In
To power the hub, connect a user-supplied 12-24V DC power adapter to the
unit and a wall outlet.
Note: The U460-4A3C-IND is compatible with listed limited power source (LPS) power
supplies from 12V DC to 24V DC. These power supplies use a 2.5 x 5.5 x 9.5 mm
input plug with either a positive tip and negative sleeve, or a negative tip and positive
sleeve.
Operation
1. Using the included USB Type-C cable, connect the USB-C port labeled
Host to your laptop, computer or any USB-C device.
2. Using the included terminal block or a user-supplied power adapter, power
the unit via the desired powering method. A blue LED will illuminate to
indicate the unit is receiving power from the power source.
3. Connect up to four USB devices to the USB-A hub ports.
4. Connect up to three USB devices to the USB-C hub ports.
5. LEDs will illuminate green as each device is connected to indicate it is
connected to the hub.
Note: If USB ports are not properly working, unplug all devices, as well as the
power source. After 10 seconds, repeat installation steps.
19-04-303-933984.indb 5
5
5/23/2019 3:37:15 PM