Beamz DMX-512MINI Manual De Instrucciones página 6

DMX Dimming control.
This unit can control 512 DMX channels.
When display shows "PA-1", it means it can control the first 64 channels. To control channel 1 – 8 push the button under
the 1st fader. To control channel 49 – 56 push the button under the 7th fader.
If you choose "PA-3", the controller can now control CH 129 – 192.
Press the button under the fader and select which channel you want to control. When button is pressed the corresponding
indicator will go ON. Each button corresponds to 8 channels.
For example: To control CH 154. Select "PA-3" (control CH129 – 192), push the button under the 4th slide (you can now
control CH 153 - 160). Slide 2 is now controlling CH154.
When selected the button, correspondending 8 channels will record the dimmer value of fader. When you didn's select the
button and move the fader, the previous dimming value will not be changed.
(Calling program or programming) Save dimming value
Press "Menu" button, display shows "C-xx"
A) Calling programm.
If display shows "C-OF" it means DMX fader control mode. You can't program at this moment.
If display shows "C-01" it means select the dimming value of scene 1. Controller will transfer the previous saved 512
dimming value to be DMX signal and send to device which was controlled.
When calling the saved dimming value, th e8 indicators under the faders will go ON and OFF. The 8 faders don't work
under this mode.
B) Programming.
When display from "C-01" to "C-30", press "ENTER", then press "UP" or "DOWN" button to enter programming. It will now
automatically enter the menu selection. When display shows "PA-1", a dot on the LED panel will flash.
When in programming state you can adjust the channel value according to above instructions. Press "ENTER" to save.
When display shows "SAVE" it means save is succesfully, and unit goes automatically enter into "C-xx" to run the data just
saved.
NOTE: You can save only when the dot in the LED panel is flashing.
Display the channel value of fader
When display shows "PA-1" press "MENU" button 3 times. The LED panel will now display the value of the channel.
In this menu the first LED digit flashes to display channel, other 3 digits display the value of this channel.
Press "MENU" to return to the menu.
Reset (Clear all memory data)
When controller is off, simultaneously press "MENU" and "ENTER" button and switch the unit "ON" to enter the reset meu.
Display shows "LOAD". Press "ENTER" to clear and it will be switched on automatically.
If you don't want to clear, press "MENU" to exit.
NOTES:
1. When setting to run the preset programms, select "C-02" and it will run the same mode by next switch "ON". Fader is
invalid at this moment. Please select "C-OF" if you need to change to manual control mode. Press "ENTER" to save.
2. You must turn the power switch to "OFF" when not using the unit. You can't only disconnect the plug, otherwise the
battery will not stop powering the unit and it will empty.
3. When battery power is not enough, it will automatically restart several times and finally have no display. The 12V
adapter should be used for powering the unit. It will charge the battery too. Full charge should be no less than 8 hours.
4. The controller has energie saving function. When it's not operated for 1 minute the LED panel will go off and just display
a flashing dot.
www.tronios.com
Copyright © 2012 by TRONIOS the Netherlands