Electrical Safety - Grizzly ELS 3027 E Traducción Del Manual De Instrucciones Original

GB
• Keep all cooling air inlets clear
of dirt.
• If an accident or fault occurs
during operation, immediately
switch off the device and dis-
connect at the plug. For the
correction of faults, read the
"Troubleshooting" chapter or
contact our Service-Centre.

Electrical safety:

• Make sure that the mains volt-
age is compatible with the infor-
mation of the label.
• Connect the device, as far as
possible, only to a plug socket
with a ground-fault circuit inter-
rupter (g.f.c.i switch), with a rat-
ed residual current at not more
than 30 mA.
• Check the device and the pow-
er cable with plug for damage
before every use. Avoid bodily
contact with grounded parts
(e.g. metal fences, metal post).
• The coupling of the extension
cord must be protected against
splashed water, it must consist
of rubber or be surrounded by
rubber. Employ only extension
cords which are stipulated for
use in the open air and are
marked accordingly. The flexible
lead cross-section of the exten-
sion cord must at least 2.5 mm
Always roll out the cable drum
completely before use. Check
the cable for damage.
• Keep the cable away from the
field of action and basically play
it out behind the operator.
• Use the tension relief provided for
the fixing of the extension cord.
72
• Do not carry the device by the
cable. Do not use the cable
to pull out the plug from the
plug socket. Protect the cable
against heat, oil and sharp
edges.
• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifications,
must not be employed. Remove
the plug immediately from the
plug socket in case of damage
to the mains cable.
Do not touch the mains power
supply cable under any cir-
cumstances until you have
pulled the plug out of the mains
socket.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the appliance if the
on/off switch does not work
properly. Always have a dam-
aged switch repaired by our
Service Centre.
• Do not overload your device.
Work only within the indicated
range of performance. Do not
employ any low power ma-
chines for heavy work. Do not
. use your device for purposes
2
for which it has not been de-
signed.
• Before each use, check the
power supply lead and the ex-
tension cable for damage and
ageing. Do not use the equip-
ment if the cable is damaged or
worn.