Tabla de contenido
Publicidad
6.1
Low Battery Indication
When the batteries are charged, there will be no battery indication.
When the batteries are low, the Low Battery icon will blink in the
display. The strobe may still be used for a short time.
Low Battery Icon =
The strobe has a protection feature that prevents the strobe from
operating if the battery voltage is too low. This condition is indicated
by no flash and the display shows "LO BAT". At this time the
batteries must be recharged. Remember to release the trigger switch.
6.2
Charging the Batteries
The unit may be recharged at any time. You do not need to wait until
the low battery condition is indicated.
To charge the battery powered strobe with the recharger:
1.
Release the trigger so the strobe is off.
2.
Plug the recharger cable into the recharger socket (located below
the display panel behind the handle).
3.
Plug the recharger into an AC mains wall outlet (115/230 Vac).
CAUTION:
When the recharger plug is inserted into the recharger jack, the strobe
will go into the Charging Mode. Make sure the trigger switch is not
depressed. The strobe will not do anything else when charging (e.g. it
will not flash and the buttons have no function).
Find Quality Products Online at:
All manuals and user guides at all-guides.com
Outline blinking (very little time left)
Use of rechargers other than the one supplied
(PSC-2U) will damage the stroboscope and void
the warranty.
GlobalTestSupply
www.
.com
sales@GlobalTestSupply.com
E-9
Publicidad
Tabla de contenido
