Vivanco MX 360 Instrucciones De Uso página 7

c) Plug the new fader into the cable and place it back in the mixer.
d) Screw the new fader to the mixer.
5. Start/Mute: The buttons Start/Mute (10) allow you to remove a channel's signal from the mix when the crossfa-
der is set to that channel.
6. Output control section: the level of the AMP (16) ist controlled by the MASTER (11) control.
Note: the REC out (36) has no level control. The level is set by the channel slides.
7. Talkover section: The purpose of the talkover section is to allow the program playing to be muted so that the mic
can be heard above the music. When the switch (12) is in the left position, the mic and talkover are both off. When
the switch is in the right position, the mic and talkover will be on and the volume of all sources except the Mic
input are lowered by 16 dB. The MIC LEVEL (13), TREBLE (14) and BASS (15) controls allow you to fully adjust
the mic signal.
8. Cue section: By connecting a set of headphones to the PHONES (9) jack, you can monitor either channel or both.
Select the Channel 1 by sliding the CUE MONITOR (24) control to the right. Use the CUE LEVEL (23) control to
adjust the headphone volume without affecting the overall mix.
9. Led Display: The LED Display indicates the Master Output AMP (16) of channel 1 or channel 2.
Specifications
Inputs
Outputs
Frequency response
Distorsion
S/N ratio
Talkover Attenuation
Power source
Power supply
Dimensions
Weight
DJ Mic 1, 2 mV
Phono 1, 5 mV
Line 150 mV
REC 0, 100 V
AMP 0, 780 V
Phones 0, 17 V
20 - 20.000 Hz +/- 2 dB
0, 05%
DJ Micro 64 dB
Phono 70 dB
Line 80 dB
- 16 dB
230 V / 50 Hz
15 V AC
(external) 25, 5 x 19, 2 x 5 cm (L/H/D)
(internal) 22, 2 x 16, 8 x 4, 2 cm (L/H/D)
1, 3 kg
7