Publicidad
Drill a 3/32" hole and attach the T-Connectors White wire
with
the ring terminal to the vehicle using the #10 screw provided.
Caution: Do not drill into any exposed surfaces or
through the vehicle body.
7. Route 4-Flat to the center of the vehicle. Attach 4-Flat to
the trailer hitch underneath the bumper for storage.
Caution: Make sure to avoid areas that could cut,
pinch or burn the wires when routing the harness
across the vehicle.
8. Mount the T-Connector Black Converter Box using the
double-sided tape provided. Secure the remainder of the
T-Connector harness under the bumper with the cable ties
provided, to prevent damage or rattling and being careful to
avoid any areas that would cut or pinch the wire.
9. Confirm correct operation with a test light or by using a
properly equipped trailer.
10. Replace both taillight assemblies taking care not to cut
or pinch the wires.
Publicidad
