Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open trunk and remove both
taillight assemblies by
removing three Wingnuts on each
taillight, and by prying and
pulling away from the vehicle.
While being careful not to
damage the alignment tabs.
3. On the driver side & passenger side
disconnect the taillight
socket connectors that match the connectors on the T-Conn
ector assembly. Taking care not to break the locking tabs
4. Beginning on the Left Driver's side, route the T-
Connector
containing the Yellow wire up from underneath the vehicle
through the opening between the bumper and body panel.
Make sure to plug the T-Connector ends firmly into the
vehicle harness connectors until they lock into place. Take
care not to damage the locking tabs.
5. Route the T-Connector end with the Green wire across the
vehicle between the bumper and body to the passenger side
taillight assembly. Repeat Step 4 for the right (Passenger)
side using the T-connector ends with the Green wire.
6. Locate an appropriate position on the vehicle frame to
attach the White wire that has the ring terminal attached to it.
Fig. 1
Publicidad
