X-lander X-MOVE Manual Del Usuario página 10

click open (picture a). Place the additional adapters in the locking devices of the chassis
(picture b) and push the car seat until the locks have clicked into place.
re using the attached car seat you need to ensure that it is properly fitted into place.
17 R E M OV I N G T H E C A R S E AT
To remove the car seat press the notch-unlocking buttons (1) on both sides of the car
seat at the same time pulling it up out of the locking devices (a). Pull the additional
adapters out of the locking devices (picture b). Fold the locks by pushing the open part
down as shown in picture (c).
18 L E D L I G H T S
The stroller frame features LED lights which light the way in front of the stroller. The ON
button is located on the stroller frame as shown in the picture below. The batteries are
located on the bottom of the footrest. In order to install the batteries LR 44, unscrew the
screw shown in the picture and take off the casing.
19 A D J U S T I N G T H E S A F E T Y H A R N E S S
The length adjusting device is on the back side of the seat unit backrest (a). To loosen
the straps press the device button and pull the safety harness (b). To tighten the straps
pull the strap coming out of the device (c).The length of the harness can be increased by
removing the tip of the hip harness from the extra hook.
20 B U C K L E
To unfasten the buckle, press the buttons and pull the fastening part out of the casing.
To fasten the buckle, insert the fastening part into the casing until it has engaged.
21 I N C R E A S I N G T H E H O O D I N C L I N AT I O N A N G L E
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
22 A S S E M B L I N G A N D R E M OV I N G T H E H O O D
To mount the hood, slide the end plastic elements through the fence (a). To remove the
hood, press the locking element and slide from the fence (b)
23 AT TAC H I N G T H E C OV E R
To attach the cover, put the straps with snap fasteners through the plastic semi-circle
and fasten the snap.
24 A D J U S T I N G T H E H A N D L E H E I G H T
Press the button in the central part of the handle and adjust its height by pulling or
pushing it towards/away from you.
25 S TO R I N G T H E C H A S S I S
When folded the chassis is free standing in a vertical position. To stand it set the length
of the handle in the position marked on the handle bar with white lines (1) and lock the
folding device in place to prevent the chassis from opening (2). The chassis must be
kept in a place inaccessible to children.
26 F I T T I N G T H E S L E E P I N G B AG
Roll the elasticated flap of the sleeping bag over the top of the seat unit backrest (a). Next,
pass the strap ends with snap fasteners on them through the D-rings and do the snaps.
27 M O S Q U I TO N E T
The mosquito net is in the pocket under the footrest (a). Place it over the footrest and
the hood (b,c) and then fasten the straps round the frame bars as shown in figure (d).
28 AT TAC H I N G X - B AG N U R S E R Y B AG A N D X - M U G H O L D E R
X-Mug and X-Bag nursery bag can be attached to the frame using the holders shown in
the picture
8
Caution: Befo-