Removing/Inserting The Battery - Milwaukee 2426-20 Manual Del Operador

SPECIFICATIONS
Cat. No. ..................................................... 2426-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
No Load OPM ................................... 5000 - 20,000
Hex Wrench ....................................................5 mm
Recommended Ambient
Operating Temperature ......................0°F to 125°F
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Changing Accessories
1. Remove the battery pack.
2. Place the tool upside down on a flat surface.
3. Use the hex wrench to remove the accessory bolt.
4. Remove the outer flange, any accessories and any
adapters (sold separately).
5. Clean bolt, flanges, adapter and accessories of all
dirt and debris.
6. Place the adapter (if necessary), accessory, outer
flange and bolt onto the tool. Determine the need
for an adapter by using the chart. Tighten securely
using a hex wrench.
Typical
Accessory
Assemblies
* *
Accessory Arbor Type
OPERATION
To reduce the risk of injury, keep
WARNING
hands away from the blade and all
moving parts.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
To reduce the risk of injury, always wear proper
eye protection marked to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Typical Applications
A large variety of accessories are available for ap-
plications such as sawing/cutting, scraping, and
sanding.
Sawing/Cutting
Install a sawing/cutting blade at an angle easy to use.
Properly clamp the workpiece. Set the speed dial to
a high speed. Start the tool and allow it to reach full
speed. Use moderate pressure to avoid burning or
scorching the workpiece.
Scraping
Install a scraping blade at an angle easy to use.
Start the tool and allow it to reach full speed. Use
light pressure and a low angle to avoid gouging and
damaging the workpiece.
4
Use adapter with this
side facing accessory
adapter not needed
adapter not needed
*
*
*
*
*
Adapters sold as
accessories